Briley 3 Gun M-Lok Handguards offer several benefits to competitive shooters:

Enhanced Ergonomics: The Briley 3 Gun M-Lok Handguard provides a firm and comfortable grip, allowing for better control and handling. It helps maintain a steady platform and absorb recoil more effectively, especially during rapid or repetitive shooting.

Improved Control: By providing a higher grip location on the shotgun, the Handguard improves recoil control and transition speed. This is particularly beneficial in dynamic shooting situations, especially competitive shooting, where precise movements and strong muzzle control are crucial.

 Heat Dissipation: Briley 3 Gun M-Lok Handguards allow airflow around the barrel, helping to dissipate the heat generated during extended shooting sessions. This helps prevent discomfort or burns caused by barrel heat and allows shooters to maintain a secure grip without the risk of injury during shooting and strong hand reloads. The 6005 aluminum extrusion wraps above the top of the barrel to protect the shooter's support side thumb from barrel heat.

Accessories Integration: Briley 3 Gun handguards feature standard M-Lok slots to mount additional accessories like stage saver adapters, lasers, lights, or sling attachments, further enhancing the versatility and utility of their shotguns. 

The 8” handguard weighs in at just 9.5 oz and is hard anodized flat black.
The 13” handguard weighs in at just 12.9 oz and is hard anodized flat black.  

The handguard ships fully assembled and installs directly in place of the factory forend with no modifications to the shotgun. 

The handguard installs in a single piece, similar to the factory M1 or M2 forends. The handguard slides over the magazine tube and into the factory forend retainer, then the barrel is placed installed as per normal. The handguard is retained between in the same two locations as the factory split forend. 

Please Note: 8-inch handguards will work with a factory forward sling loop, while 13-inch handguards will require the removal of the factory forward sling loop.

When installing the Briley M4 Handguard on a Benelli M4 T-Pro model the Benelli Forend spring set will have to be installed into the lug on the barrel. This spring set contains one each of Benelli part numbers 70099, 70100, and 70101.

USA made and counts towards 922(R) Compliance 

Please note, the 8" handguard will not fit with the factory QD sling mount.  The loop sling mount will work.

When installing the Briley M4 Handguard on a Benelli M4 T-Pro model, the Benelli Forend spring set will have to be installed into the lug on the barrel. This spring set contains one each of Benelli part numbers 70099, 70100, and 70101.  On M4 clone guns (PSA, GForce, Panzer, Etc.) the retaining pocket for these springs is not machined into the barrel lug so the spring set will not be retained if installed.

Please note, if you are using a Midwest Industries Handguard DO NOT tighten the gold set screws on the bottom of the handguard as it may crack the carbon fiber magazine.